the story of Gunnar, David and Schorsch…

Kubentypen03This isn’t Gunnar but made by Gunnar. Gunnar is a friend who makes actionfigures and just made that little guy. He is made of wood and around 50mm high.

Kubentypen02This isn’t David but it’s scanned using the David-Laserscannersoftware with an Optoma PK301 and a Microsoft Lifecam-Studio. It took about 1.5hrs to get the hole figure but i think you can make it in 30min. Here he sits in Blender, From 750k faces (50MB out of David) to 10% (75k faces).

Kubentypen04This isn’t Schorsch but SchorschXY printed it.





That little guy hasn’t got a name jet, i think. How about “Lampshade”:


the last picture shows the two Prints of Lampshade a little better than the earlier one:


The white spots are where the support stucked on the model, you can easy get rid of that using acetone and your finger… A few missing perimeters are caused by low-quality-ABS (waterbubbles) and single-walled-perimeter (left one) The right one is a reduced one with only ~7500 triangles.

One thought on “the story of Gunnar, David and Schorsch…

  1. Pingback: Honey, i remeshed the cube-head! | audioTS

Leave a Reply

Please log in using one of these methods to post your comment: Logo

You are commenting using your account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s